njtffpzw

Moderator: Angel

Post Reply
RRlocoENGR
Newbie
Newbie
Posts: 2
Joined: Sat Nov 20, 2010 7:15 am

Starting problems with 52HM84

Post by RRlocoENGR » Sat Nov 20, 2010 7:24 am

I have a 52HM84 television. Sometimes the set will not come on, the red and green lights flash together after the set attempts to come on eight times. I know that this is supposed to indicate that the lamp is not operating properly, but there are times that the set will come on fine and the picture is good.

My question is this, could the lamp be bad even though it still comes on most of the time and works great? I have ordered a new lamp and hope that solves the problem, but I am not sure that it is the lamp. What might cause the set to give this indication if it is not the lamp?

Thanks!

User avatar
grayfox
Jedi Master
Jedi Master
Posts: 1049
Joined: Sat Jun 13, 2009 9:40 pm
Location: Sunny San Diego!
Contact:

Re: Starting problems with 52HM84

Post by grayfox » Wed Jan 19, 2011 11:43 pm

hello!
judging by the repeated ignition cycles I would recommend you replacing your lamp ballast soon since it is a consumable part in your TV, but I would not eliminate the probability of it being the lamp.
from a logical standpoint I would start by replacing the lamp and if the problem persists, then I am pretty sure the ballast needs to be changed.
ImageUnit Foxhound

RRlocoENGR
Newbie
Newbie
Posts: 2
Joined: Sat Nov 20, 2010 7:15 am

Re: Starting problems with 52HM84

Post by RRlocoENGR » Thu Jan 20, 2011 2:43 am

pepe wrote:hello!
judging by the repeated ignition cycles I would recommend you replacing your lamp ballast soon since it is a consumable part in your TV, but I would not eliminate the probability of it being the lamp.
from a logical standpoint I would start by replacing the lamp and if the problem persists, then I am pretty sure the ballast needs to be changed.


Thanks for you input. I have replaced the bulb and occasionally the tv will not start still. Is the ballast something I can change? Could you tell me what to do to replace it? Is it a inexpensive part?

Thanks again!

Wimlok
TV Wizard
TV Wizard
Posts: 481
Joined: Fri Apr 24, 2020 10:59 pm

njtffpzw

Post by Wimlok » Fri Mar 17, 2023 6:57 pm


Post Reply

Return to “Akai DLP Discussion”